AJAS Cover
Frequency: Continuous
ISSN: 1546-9239 (Print)
ISSN: 1554-3641 (Online)
Research Article Open Access

Investigating the Influence of Different Process Parameters on Shrinkage of Injection-Molded Parts

A. R. Jafarian1 and M. Shakeri1
  • 1 Faculty of Engineering, Mazandaran University, Shariati Ave. PO Box 484, Babol, Iran

Abstract

Different models have been proposed to investigate the effects of various process parameters on shrinkage of plastic parts, which in most cases the effect of each parameter is obtained by changing one factor at a time. In this research, a simple flat model has been used and a simulation code has been developed. Then, through this simulation code, the effects of different process parameters have been investigated. This code was run for a typical thermoplastic (polycarbonate) and finally, a Design Of Experiments (DOE) approach was used to study the effects of multiple variables on shrinkage simultaneously.

American Journal of Applied Sciences
Volume 2 No. 3, 2005, 688-700

DOI: https://doi.org/10.3844/ajassp.2005.688.700

Submitted On: 30 November 2005 Published On: 31 March 2005

How to Cite: Jafarian, A. R. & Shakeri, M. (2005). Investigating the Influence of Different Process Parameters on Shrinkage of Injection-Molded Parts. American Journal of Applied Sciences, 2(3), 688-700. https://doi.org/10.3844/ajassp.2005.688.700

Open AccessCopyright: © 2005 A. R. Jafarian and M. Shakeri. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.

  • 3,402 Views
  • 3,048 Downloads
  • 4 Citations

Download

Keywords

  • Computer-aided Engineering (CAE)
  • Injection Molding
  • Shrinkage
  • Residual Stress
  • Design of Experiments (DOE)